* Applicable vehicle models: European imported cars/ GM (impala) some models/ Tesla some models

​

*Application part: Sedan-Aluminum alloy wind door trip / eyebrow molding

​

: RV-Aluminum Alloy Window Trip / Eyebrow Molding / Roof Rack

​

*Not applicable vehicle types: Vehicles other than the applied vehicle types

​

*Not applicable parts:

​

----Chrome plated areas other than the applied areas (e.g., front/rear grill, side chromium plated, etc.)

​

​

​

Shake the undiluted solution and use it.

We work with safety equipment.

Please work after checking whether it is aluminum alloy or plating.

​

​

1. Depending on the condition of the contamination, there is a difficulty in working.

* Proceed with the work after the test work

Deep scratches/depositions are >> non-restoreable or mitigated.

​

​

​

​

2. Safely mask(1st 45mm,2nd 24mm,3rd 15mm) the work area with tape before construction and remove foreign substances.

*When removing contaminants (degreasing) Use a wet towel or disinfectant ethyl alcohol.

​

​

​

​

 

​

​

​

3. After wetting 1-2 drops on the sponge pad (applying), apply it before and after about 20cm of the work area

​

​

 

​

​

4. Cut the enclosed scrub sanding pad slightly larger than the size of the sponge (applying) block.

(Use the sponge block as a hand block.)

​

 

​

​

​

 

​

​

​

​

After about a minute, apply a slight force to the scrub sanding pad in a certain direction and sand it.

>When you do polishing, you will get a removal point at some point.

(!Depending on individual work proficiency and vehicle molding pollution conditions, the timing of decontamination is different!

Please proceed with the polishing until the point comes out.)

*When working on restoration,

Using a machine to polish molding increases efficiency.

(First of all, learn how to work with your hands and try working with the machine.)

​

When using air sanding, add oil from time to time.

(Too much force causes deep damage when sanding scrub sanding pads)

When the work part dries, the chromium molding cleaner needs to be replenished.

Scrub sanding pads are consumable.

​

​

 

 

​

​

​

​

5. After sanding, check the work condition after skimming the work area with a wet towel/ethyl alcohol for disinfection.

​

Repeat if contamination remains.

​

 

​

6. Coating after removing foreign substances. (Any coating agent in use is possible.)

If the restoration work is a little insufficient, you can get better results if you polish it and coat it with glass.

​

7. Solution storage method-Cool place without direct sunlight or preferably in a refrigerator.

​

8. Avoid direct sunlight and wear protective gear as well as possible indoors.

9. No matter how safe the drug is, it's just a drug.Follow the safety guidelines.

10. Beware of Freezing in Winter

​

= Dark black is also possible. However, I hope you can reduce your strength when polishing.

(You can think of it as similar to the black one when you work on it.)

If a scratch occurs, please polish it.

If there is a fine stain, apply a covering glass film coating agent.

* If there is any residue stain of the medicine left after polishing, apply the medicine again and wipe it quickly with disinfectant alcohol.

​

Precautions.

​

On the stamping surface/glass don't let construction chemicals get on you.

Remove foreign substances quickly if stained.

Do not use the high glossy part.